Wrangler JL Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have a 2020 JL with the factory tow package which comes with the pre-wired auxiliary switches on the center console. Got the Quadratec 3 inch square LED bumper lights installed on a Body Armor full bumper. What is the best wiring route for installing the Quadratec wiring harness to one of the four auxiliary switches? The leads for the pre-wired switches is up front by the battery.

All replies are greatly appreciated.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.